Next to the ‘ DHCP server’ option, click on ‘ Off’.If you assign an IP address yourself, ensure it is within the range of the main router ( 192.168.2.2-254). You can leave these as is if in any doubt, unless your primary wireless network has a large number of devices (over 250) connected to it. The defaults for the IP and Subnet Mask are 192.168.2.254 and 255.255.255.0 respectively. Enter an IP address for the access point that doesn’t conflict with any other devices on the network.Under the ‘ LAN Setup’ section, click on ‘ LAN Settings’.Enter a name for your new wireless network that is different from the one provided by the main router.Otherwise you should be able to leave it empty. Log into the router using your admin password, if you have set one up.Type or 192.168.2.1 into the browser’s Address bar.Connect a device to the new wireless network.Connect your access point to the main router using an Ethernet cable between the LAN ports on each device.You should be fine leaving the Subnet mask as default. By default, the IP will be set to 192.168.2.254, but you can change this to anything that doesn’t conflict with an existing device on the network. This needs to be within the range of the main router ( 192.168.2.2-254). Enter a unique IP address for the access point.Make sure this is the same as your current network settings (The default IP is 192.168.2.1, and the default Subnet mast is 255.255.255.0). Next, set the IP address and Subnet mask of the router.Under the ‘ Wireless’ section, click on ‘ Use as Access Point’.Enter the name of the access point’s wireless network in the SSID field.Under the ‘ Wireless’ section, click on ‘ Channel and SSID’. #Belkin router password#If you have not set up a password yet, then you should be able to leave this blank. Log into the router using the admin password.In the Address bar, enter either or 192.168.2.1 (this is the default IP address for Belkin routers).Open your web browser, such as Chrome, Firefox, or Edge.The second option is only necessary if your router doesn’t give you the first one. You have two options for configuring your Belkin router as an access point: activating the ‘Use as Access Point’ setting, or disabling the DHCP server on the router. For the best results, make sure both routers are the same make and model. Routers from different manufacturers are not guaranteed to work together, though you will have better luck if they are using the 802.11n standard.Make sure that you have a working internet connection before setting up your new access point.Any Ethernet cables that are connected to it must be plugged into ports 1 to 4. When setting up a wireless router to work as an access point, you can no longer use the Internet port on the router.An LED will flash on the LAN port to show you that the cable has been properly connected. Before you start, you need to connect one of the router’s LAN ports to your computer with an Ethernet cable, and also ensure that the router is switched on. #Belkin router how to#In this article, we’ll show you how to set up a Belkin Router as an access point so that you can be sure that you’ll be able to maintain a strong wireless connection wherever you roam, at work or at home. Access points are one of the main solutions to this issue.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |